Spout Spotter Installation
Kit Contents
1. hose clamp (pn 56232 – qty 1)
2. magents (pn 62411 – qty 2)
3. cable ties (pn 41939 – qty 18)
4. light (pn HOP 200018 – qty 1)
5. bracket (pn RST 100001 – qty 1)
6. splitter cable (pn HOP 200017 – qty 1)
7. cable (7 lengths available, pn HOP 200025 – 200031 – qty 1)
Installation Instructions
- Starting at the Hopper Walker base unit, unplug existing hopper light.
- Route splitter cable behind small tarp strap that secures the joystick box to the Hopper Walker mounting plate.
- Plug Spout Spotter splitter cable into light cable from the base, and then into the existing hopper light.
Install splitter cable.
Install extension cable.
- Plug spout light extension cable into splitter cable.
- Plug spout light extension cable into splitter cable.
Install extension cable.
- Route extension cable up swing auger to boot.
- Secure extension cable to existing Hopper Walker power cable
Route and secure extension.
Center cable.
- Route the extension cable to the main auger tube. Use the two magnets to secure the cable to the front and back of the boot.
- IMPORTANT: Center cable on main auger tube by boot to avoid pinch points.
- Route the extension cable to the main auger tube. Use the two magnets to secure the cable to the front and back of the boot.
- IMPORTANT: Center cable on main auger tube by boot to avoid pinch points.
Center cable.
- Route extension cable on top of the main auger tube.
- The light will mount approximately 7′ from the spout.
Mount 7′ from spout.
Factory mount.
Spout Spotter hardware.
- If your auger has a factory mount, mount the light directly to the mount.
- Otherwise mount the bracket onto auger auger light.
- Then use the hose clamp to secure the auger light in place.
- If your auger has a factory mount, mount the light directly to the mount.
- Otherwise mount the bracket onto auger auger light.
- Then use the hose clamp to secure the auger light in place.
Factory mount.
Spout Spotter hardware.
- Use cable ties to secure the extension cable to the main auger frame.
- Loop and secure any excess cable neear the spout light.
- To operate the Spout Spotter light, when your Hopper Walker has been powered up, press the “ON” button on the remote. The spout light and the hopper light will stay on for approximately 20 minutes, then automatically turn off. You can manually toggle the lights on/off by pressing the “ON” button on the remote.
WARNING:
HOPPER WALKER LIGHTS MUST BE TURNED OFF DURING AUGER TRANSPORT ON ROADS.
ABOUT US
Hopper Walker® is manufactured by Rust Sales, Inc. located near Harwood, ND. Rust Sales, Inc. has been providing Innovative Solutions for Today’s Farmers since 1979.
